External Sources; Timer Setting; Listening To External Sources - Philips FW-V720 User Manual

Before setting the timer, make sure the music
source has been prepared.
VCD – Load the disc(s). To start from a specific
track, make a programme (refer to "CD/VCD/
MP3-CD Operation - Programming the disc
tracks").
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 2.
3
Press à or á on the system repeatedly to set
the hour for the timer to start.
4
Press í or ë on the system repeatedly to set
the minute for the timer to start.
5
Press CLOCK•TIMER to store the start time.
"TIMER ON" will be displayed and followed
by the set timer "XX:XX" and then the selected
source.
will remain on the display.
TIMER
At the preset time, the selected source will play.
To exit without storing the setting
Press Çon the system.
STANDBY-ON
ECO POWER
MP3 - CD
DISPLAY PROG
DEMO
PLAY•
STOP/
PAUSE
CLEAR

Listening to External Sources

1
Connect the audio out terminals of the external
equipment (TV, VCR, Laser Disc player, DVD
player or CD Recorder) to the AUX/CDR IN
terminals of your system.
pg 001-032/V720/21-Eng
1
2
1
2
2
MUSIC LEVEL
INTERACTIVE VU MET
CLOCK• AUTO
DUBBING REC
TIMER REPLAY
CD 1•2•3 BAND
VCD
PAL/ TUNER
NTSC
SOURCE
ON • OFF LEVE
DYNAMIC AMPLIFICATION CON
TAPE AUX
TAPE 1•2 CDR / DVD
MIC/
LEVEL
29
Clock/Timer
To deactivate the TIMER
Press and hold CLOCK•TIMER for more than
two seconds.
Press Çon the system to cancel the timer.
The display will show "CANCEL" and
will disappear from the display.
To activate the TIMER (for the same preset
time and source)
Press and hold CLOCK•TIMER for more than
two seconds.
Press CLOCK•TIMER again to store the start
time.
The last set timer information will be shown
for a few seconds and
TIMER
the display.
Notes:
– If the source selected is VCD, playback will begin
with the first track of the last selected disc or other
trays if disc is empty. If all the disc trays are empty,
TUNER will be selected instead.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.

External Sources

Press AUX (CDR/DVD) repeatedly to select
CDR/DVD mode or normal AUX mode.
"CDR/DVD" or "AUX" will be displayed.
If the sound from the external source is
distorted, select CDR/DVD mode for listening.
Notes:
– You are advised not to listen to and record from
the same source simultaneously.
– All the navigation sound control features (DSC or
VAC for example) are available for selection.
– Refer to the operating instructions for the
connected equipment for details.
For Recording, please refer to "Tape
Operation/Recording".
6/5/01, 6:42 PM
TIMER
will appear on
29
3139 115 20912