DAHAO BECS-D16 Owner's Manual page 142

Chapter 10 JF type sequin embroidery
(2) L/R Sequin Feeding Angle Adj.
It is used for adjusting sequin feeding angle.
(3) Auto start for sequin:
When the setting is "Yes", system will start embroidering sequin automatically.
When the setting is "No", machine needs manually start.
(4) Time of Sequin Action:
This is to set the time from sequin device going down to embroidery (0-15, the
default value is 2). If the sequin-feeding device is controlled by valve, please use
the default value; if that device is controlled by motor, please select 4-5.
(5) Sequin off after T.B.(T.B: Thread-breakage)
When the setting is "Yes", sequin presser foot will go up automatically in case of
thread breaks. When the setting is "No", user needs manually lift the presser foot.
(6) Sequin Ind. Up Down
When the setting is "Yes", the action of the sequin device will be independent.
When the setting is "No", the action will be collective.
(7) Up Valve When Jump & Nocut.(No,Yes)
(8) L/R Motor Shift Stroke Base.
(9) L/R Motor Shift Stroke Time.
(10) With Origin at L/R Motor Shift.
The parameters No.8, No.9 and No.10 at above are for the special sequin device
which uses the motor of single needle dual-sequin device to shift the travel
amounts of large sequin and small sequin. This kind of device contains two types:
the one is with shift origin; the other is without that shift origin.
136 BECS- D16 computerized embroidery machine owner's manual