Honeywell SS500 Series Installation Instructions

Installation Instructions for the
SS500 Series Temperature Compensated
Hall Effect Sensors
WARNING
PERSONAL INJURY
DO NOT USE these products as safety or
emergency stop devices or in any other application
where failure of the product could result in personal
injury.
Failure to comply with these instructions could
result in death or serious injury.
CAUTION
ELECTROSTATIC DISCHARGE DAMAGE
This component is sensitive to electrostatic discharge
(ESD). Take normal ESD precautions in handling this
product to prevent ESD-induced damage and/or
degradation.
Failure to comply with these instructions will
result in product damage.
CAUTION
WAVE SOLDER DAMAGE
DO NOT wave solder this product. Wave soldering
may negatively affect the sensor performance and
reliability. Subjecting the sensor to wave soldering
will void Honeywell's warranty.
Failure to comply with these instructions will
result in product damage.
OPERATING CHARACTERISTICS (over Operating Voltage and Temperature, unless otherwise noted)
Supply Voltage
Current Consumption
Output Voltage (operated)
Output Current (operated)
Output Leakage Current (released)
Output Switching Time
Rise, 10 to 90%
Fall, 90 to 10%
Operating Temperature Range
Note: To prevent damage to the leads, SS500 Series surface mounted sensors are
supplied only on tape and reel.
Sensing and Control
ABSOLUTE MAXIMUM RATINGS*
Supply Voltage
Voltage externally
applied to output
Output ON Current
Operating Temperature
Storage Temperature
Magnetic Flux
* Absolute maximum ratings are the extreme limits that the
device will withstand without damage to the device.
However, the electrical and mechanical characteristics are
not guaranteed as the maximum limits (above
recommended operating conditions) are approached, nor
will the device necessarily operate at absolute maximum
ratings.
SOLDERING INSTRUCTIONS
Honeywell recommends an infrared reflow process
with peak temperatures not to exceed 245°C (473°F)
for 10 seconds maximum.
BLOCK DIAGRAM
Min. Typ. Max.
⎯
3.8 30
⎯ ⎯
10
⎯
0.15 0.40
⎯ ⎯
20 mA
⎯ ⎯ 10 µA
⎯ .05 µs 1.5 µs
⎯ .15 µs 1.5 µs
-40°C to +125°C (-40°F to 302°F)
-1 to +30 VDC
+30 VDC max. (OFF only)
-0.5 VDC min. (OFF or ON)
See Table A.
-50 to +160°C
(-67 to +320°F)
-65 to +160°C
(-85 to +320°F)
No limit. Circuit cannot be
damaged by magnetic
overdrive.
TRIGGER
HALL
CIRCUIT
SENSOR
AND
AMPLIFIER
Remarks
VDC
mA
Sinking 20 mA max.
V = 12 V,
CC
= 1.6 K Ω,
R
L
C = 20 pF
L
ISSUE 5
PK 80079
Vs (+)
OUTPUT
(0) N.H.
GROUND (-)
TABLE A
Output Current
Absolute Limits
Supply Output
Voltage Current
Max. mA
-1 to 24 50
24 to 25 37
25 to 26 33
26 to 27 28
28 to 29 19
29 to 30 15