Factory Reset; Software Update - ZGEMMA STAR 2S User Manual

Change service pin
109*
II
Here you can define a PIN code required to change services to
be included in die parental control list
(^K^e hereis used for Change service and thus you
recorniftehded to use a PIN code different from that used
5.2.5 Factory Reset
[ O : MENU > Setup > Factory Reset)
If you want to erase all installed service list as well as all
configurations, run the Factory Reset process. Select YES in the
below menu to run the factory reset.
Upon the completion of factory reset process, your ZGEMMA-
STAR 2S wffl reboot automatically and startdie FffstTime Installation
including bouquets, service lists, satellite parameters, and.!
pn will be erased.
5.2.6 Software Update
ZGEMMA-STAR 2S can be updated in two ways. Firstly, you can update ZGEMMA-STAR 2S software by going into Menu >
Setup > Software Update. You can also try USB update as In the following step.
Stepi: Download new software image from forum http:// www.zgemma.tv
Step2: Extract new software image using winrar, windp or other extracting tool and copy on a USB stick. All files shall be under
/zgemma/sh1 directory.
/zgemma/sh1/noforce
/zgemma/sh1/imageversion
/zgemma/shl/kernel.bln
/zgemma/shl/rootfs.bin
Step3: Power down the ZGEfVirvlA-STAR 2S by the power switch.
Step4: Place USB stick in the USB slot at the rear side of the ZGEMMA-STAR 2S.
StepS: Power up the ZGEMMA 2S. When the LED shows "USB", press power button. After about 3 minutes,
upgrade will complete. Then ZGEMMA 2S reboots automatically.