ZGEMMA STAR 2S User Manual page 22

5.2.1.3 Network Setup
[ O : MENU > Setup > System Settings > Network Setup]
Z6EMMA-STAR2Sis integrated with standard lO/IOOMbps
Ethernet with RJ 45 connector standard. You are recom
mended to use this network capability ofZGEMMA-STAR 25 to fully
enjoy the system. You can set up the network settings
through this Network Configuration menu.
In the Network Configuration menu, you will see five sub
menus as follows:
I
'
1 Adaptersettings
Use Interface
YES is used to activate the Ethernet. If you set this option at NO,
the Ethernet will not work.
Use DHCP
YES is used to use DHCP (Dynamic Host Configuration
Protocol). If you set this option at YES, it will automatically
detect the correct IP address. NO is used when you want to use
a certain fixed IP address. In this case, you need to enter correct
addresses in each field.
2 Nameserver settings
This option is required if you selected not to use DHCP. You need to enter the address of the Nameserver.
3 Network test
When you are not sure whether the network configuration has been done correctly or not, you can run this test.
4 Restart Network
This option is used when you want to reboot the Ethernet of your 3SEMMA-STAR2S
5.2.1.4 Language Selection 5.2.1.5 Time zone
II
I
Ml
[ 9 : MENU > Setup > System Settings > Language]
A variety of languages are available for the OSD of
ZGEMMA-STAR 2S.
( 9 : MENU > Setup > System Settings >T!mezone]
You can set your time zone in this menu,
Using LEFT/RIGHT key, you can find a time zone that you
want to use foryour ZGEMMA-STAR 2SAftef selecting a time
zone, press GREEN to confirm and save the changed setting.