Table of Contents
Advertisement
Laser Dome Camera LD200/400 PTZ
f.
Menu control of illuminator: the system normally in a state of "AUTO", using the
sensitive components to inspect the outside light, automatically open or close the
illuminator; if you need to open the illuminator in special conditions, you can use
the menu to change the state into "ON", at this time the laser illuminator will start
(not affected by outside); similarly, if you need to close laser illuminator, you can
use the menu to change the state into "OFF", at this time the laser illuminator will
close (not affected by outside).
2.low light level color to black integrated camera
a. Use menu to set the function of camera.
b. Automatic switch between color and black/
white: when the light intensity is higher than
set, the camera is in a state of "color"; when
the light intensity is lower than set, the camera
is will automatically change into a state of
"black/white", combining with laser illuminator
to realize night monitoring.
c. Zoom adjust: you can adjust "WIDE" or
"TELE" according to your needs to realize the
adjust of image.
d. Auto focusing: the camera uses the image
identity technology to realize automatic focus;
the image is clear and steady.
e. Back light compensation: when the background is too dark, you can open the back
light compensation according to your need.
f.
White balance: when confronted with the situation of image color distortion , you
can choose the best imaging mode according to your practical situation (there are
six modes to choose,
④automatic following mode ATW ⑤ automatic mode
g. Low light level set: normally the camera is in a state of automatic working; when
the environment brightness is lower than 1Lux, the camera will automatically
change into zero level state. You can also use manual method to make the
camera in a state of zero level.
3. Integrated full range shift pan-tilt
a. Pan rotate 360º, tilt rotate 0º∼95º with
180°auto moving function.
b. Pan rotate can realize 0.05~360°/s continuous
shift adjust, tilt rotate can realize 0.05~180°/s
continuous shift adjust.
c. Low speed steady rotate, little noise, clear and
steady image.
d. Realize full range no spot monitoring,
exact orientation could reach ±0. 1°.
① indoor mode ② outdoor mode ③one push mode
CONTROL SETUP
= = = = = = = = = = = = = = = =
8
www.laseroptronix.se
CAMERA SETUP
= = = = = = = = = = = = = = = = = = =
1 SHUTTER +2
2 BACK LIGHT
OFF
3 ICR SHOT
AUTO
4 D-ZOOM
OFF
5 WB SET
AUTO
6 SSNR
MIDDLE
7 APERTURE
8 AGC
AUTO
9 RETURN
1 HOME OPTION
2 LASER LIGHT
AUTO
3 WIPER
OFF
4 WIPER MODE
5 DEFOGGER
6 ZOOM RATIO
7 RETURN
5
SERIES
OFF
0 1
Advertisement
Table of Contents
