Table of Contents
Advertisement
Laser Dome Camera LD200/400 PTZ
c)
Night vision camera has the function of memory when power off, with which the
data can't be lost
d)
Main set of the menu, please refer to the "Menu Setup"
2.Menu Setup
a.
MAIN MENU
DISPLAY SETUP：Enter the submenu of screen display set. You can set ID
display、pre-setting position title display and camera display mode。
CAMERA SETUP: Enter the submenu of camera parameter set.
CONTROL SETUP：Enter the submenu of night vision control parameter set.
PROGRAM: enter the submenu of night-vision enhancements.
CAM DEFAULT SET: restore default settings.
COMMUNICATION SET: enter sub-menu of communication parameter.
SYSTEM RESET: achieve System reset function.
EXIT：exit the main menu.
b.
DISPLAY SETUP
ID DISPLAY: When this item is ON, the screen
will show the address of the night vision
camera, for example, "CAM 006". Default set is
ON.
ID POS：Set the address display position. The
address can be displayed at the three corners
of the screen: TOP-L( top left), BOTT-R (bottom right), BOTT-L (bottom left).
TITLE DIS：If this item is set ON, the left of the screen
will show the title of pre-setting position when you call the
pre-setting position. For example, "NO.001 ABCDEFGH".
If there is no title of this position, it will only display
"PRESET NO.001 NO TITLE". The set of amendment of
pre-setting position's title is under the menu of
PROGRAM. When the title of show off, the screen only shows preset number.
PRESET POS：Set the display position of pre-setting position's title. It could be
the first line to the tenth line. The first line is on the top of the screen.
CAM DISPLAY: If this item is set "ON", the camera's screen display will be open.
the camera function parameters is on the screen.
RETURN: return to the main menu.
2.3 CAMERA PARAMETER SETTINGS
Frame accumulation: there are three options: automatic, shutter and slow gate. The door
series of slow gate and shutter are 16 and 6 separately. If a slow shutter and door state,
when the camera screen display is open, the monitor will display the frame rate of
COMMUNICATION SETUP
= = = = = = = = = = = = = = = =
1 CAM ID
2 PROTOCOL
3 BAUD
4 RETURN
10
www.laseroptronix.se
001
PELCO-D
2400bps
NO. 001
PRESET POINT:
TILT ： NO TITLE
CLOSE：
EXIT
Advertisement
Table of Contents
