Set Up Instructions Braille Voyager 44 - Optelec Braille Voyager 44 User Manual

Tieman

1.3 Set up Instructions Braille Voyager 44

Follow these instructions before you install your Braille Voyager 44!
1. Make sure your screenreader is installed.
2. Close your screenreader.
3. Take your Braille Voyager 44, USB cable and Installation CD out the
backpack.
4. Place the Braille Voyager 44 in front of you so you can read the Tieman label.
5. Plug your USB cable into the back of your Braille Voyager 44.
Use the small connector and keep the symbol placed up (you can feel the
USB symbol).
6. Open your Braille Voyager 44 by using the finger opening on the front of the
unit.
7. After lifting up the cover a bit, you can pick up the cover and place it behind
the unit, while keeping the rubber strip on the cover facing upwards.
8. Route the USB cable thus that it goes to the back through the finger opening.
9. Place your laptop/keyboard on top of your Braille Voyager 44.
10. Put the installation CD into your laptop/PC.
The installation CD will tell you when to plug the USB cable into your laptop or
PC.
Braille Voyager User manual 2.2
Braille Voyager
page 4 of 20