Table of Contents
Advertisement
Disassembly
34
3.
After the snaps are disengaged, lift up the front housing straight upward.
Route the hydraflex carefully through the opening in the front housing without
damaging the flex.
Front housing
Figure 23. Removing the Front Housing
4.
To replace, carefully thread the hydraflex through the opening in the front
housing.
5.
Lower the front housing onto the chassis assembly metal guide.
6.
Press down on the front housing to engage the two housing snaps to the chassis
metal guide.
7.
Replace the keypad, transceiver board assembly, daughter board assembly,
rear housing, SIM, battery, and battery cover as described in the procedures.
March 13, 2007
Hydraflex
Z6
061760o
6809506A96-O
Advertisement
Table of Contents
Troubleshooting
