Setting The Material Sensor; Loading Transfer Ribbon - Hellermann Tyton TrakMark DS Series Operating Instruction

TrakMark DS Series

4.1.3 Setting the Material Sensor

Screw to lock
sensor position
The material sensor (2) can be shifted perpendicular to the direction of media flow for adaptation to
the media. The sensor unit is marked with indicators (4) on the label sensor retainer.
► Slightly loosen the screw (3) with Allen key (1).
► Position sensor by moving it in such a way that the sensor can detect a gap or material
Tighten the screw (3).
►

4.2 Loading Transfer Ribbon

Notice!
With direct thermal printing, do not load a transfer ribbon; if one has already been loaded, remove it.
Fig. 10 Load transfer ribbon
Operating Instruction
Align material centrally with
sensor indicators
9a
Figs. 9 a & b Setting the material sensor
9b
Inside wound ribbon
Outside wound ribbon
Fig. 11 Transfer ribbon feed path
14