Philips LX3750 User Manual page 10

Connections
Rear of TV
(example only)
AUDIO IN AUDIO OUT DIGIT AL
ANTENNA
WOOFER
LINE OUT
AM
FM (75 )
TV/A V AUX OPTICAL
IMPORTANT!
– If the picture is distorted, check the Video
Output setting. Make sure it is set to 'S-Video', see
page 19, System Setup (DVD) - Video Out.
Using S-Video In jack
– Use the S-video cable (not supplied) to connect the
DVD system's S-VIDEO OUT jack to the S-Video input
jack (or labeled as Y/C or S-VHS) on the TV.
– To hear the TV channels through this DVD system, use
the audio cables (white/red) to connect TV IN (L/R) jacks
to the corresponding AUDIO OUT jacks on the TV.
Before starting operation, press TV/AV on the remote to
select "TV/AV" in order to activate the input source.
– Deactivate Progressive Scan through System Menu. See
page 21, System Setup (DVD) - Setting the Progressive Scan
Mode.
C
10
ONNECTIONS
Y
S-VIDEO IN
OUT AUDIO
VIDEO IN
Y
VI DEO OUT
IN
S-VIDEO VIDEO
AC MAINS~
1
OUT
CO AXIAL
RF coaxial cable to TV
Back of RF Modulator
(example only)
INT IN TO TV VIDEO AUDIO IN
IN R
Antenna or
Cable TV Signal
SR SL SW
COMPONENT
VIDEO OUT
Pr/Cr
(8 )
SPEAKERS S
IMPORTANT!
– If your TV only has a single Antenna In jack (or
lapelled as 75 ohm or RF In), you will need an RF
modulator in order to view the DVD playback on
the TV. See your electronics retailer or contact
Philips for details on RF modulator availability and
operations.
Using an accessory RF modulator
– Use the composite video cable (yellow) to connect the
DVD system's VIDEO OUT jack to the video input jack
on the RF modulator.
– Use the RF coaxial cable (not supplied) to connect the
RF modulator to your TV's RF jack.
– Deactivate Progressive Scan through System Menu. See
page 21, System Setup (DVD) - Setting the Progressive Scan
Mode.
L
CH3 CH4
VIDEO OUT
S-VIDEO VIDEO
Pb/Cb Y
1