Other Functions; Tuning To Radio Stations; Presetting Radio Stations; Listening To Preset Radio Stations - Philips LX3750 User Manual

Tuning to radio stations

1
Press STANDBY ON to switch on the last selected
source.
2
Press SOURCE (or press TUNER) to select TUNER
mode.
3
Press TUNER again to select the desired band : FM or
AM.
Press and hold S or T until the frequency indication
4
starts to change, then release.
The system automatically tunes to the next strong radio
station.
FM 103.50
To tune to a weak station, press S or T briefly and
repeatedly until an optimal reception found.
5
Repeat step 4 if necessary until you find the desired radio
station.

Presetting radio stations

You can preset up to 40 stations regardless of the
reception.
1
Tune to your desired radio station (refer to "Tuning to radio
stations").
2
Press PROGRAM.
"PROGRAM" appears.
P00
PROGRAM
3
Use the numeric keypad (0-9) to select the desired
preset number.
P01
PROGRAM
SUB
103.50
SUB
103.50
SUB

Other Functions

Note:
– If "PROGRAM" icon goes off before you select the desired
preset number, press PROGRAM again.
4
Press PROGRAM again to store the radio station.
"PROGRAM" icon stops flashing.
Repeat steps 1–4 to store other radio stations.
Notes:
– The old stored content in the selected address will be
covered when you operates the unit as above.
– During programming, if no key is pressed within five
seconds, the system will exit the program mode automatically.
Listening to preset radio
stations
In tuner mode, press 1 or 2 or use the numeric keypad
(0-9) to select the desired preset number.
The preset number, radio frequency, and waveband are
displayed.

Sleep timer setting

The sleep timer enables the system to switch to standby
mode automatically at a preset time.
1
Press SLEEP repeatedly to select a preset time.
The selections are as follows (time in minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120™ OFF ™ 15...
45
SLEEP
2
When you reach the desired length of time, stop pressing
the SLEEP button.
"SLEEP" icon appears.
To check the remaining length of time after sleep
timer is activated
Press SLEEP once.
To change the preset sleep timer
Press SLEEP again while the remaining sleep timer is
shown.
The display will show the next sleep timer options.
To deactivate the sleep timer
Press SLEEP repeatedly until "OFF" is displayed, or press
the STANDBY ON button.
MIN
SUB
O F
THER UNCTIONS
27