Table of Contents
Advertisement
HYDRAULIC TRANSMISSION
For the HYDRAULIC transmission use oil AGIP DIESEL SIGMA SAE 30 o Textran TDH.
Oil used in the closed circuit of the hydraulic engine is contained in a tank Pic.1 fixed on the handlebar support. This
tank contains also a filter with metallic net Pic.2, that can be easily extracted pushing it down and taking it off from
the upper hole Pic.3. After the extraction the filter can be cleaned.
In case of complete replacement of the circuit's oil contained in the tank, is necessary discharge air from the circuit.
This operation can be done with the engine at the lowest, wheels raised and tank's oil without cap (Pic. 2) working
gradually on the control lever (Pic. 1 page. 11) alternatively forward and back up the wheels are moving. Obviously
the control lever (Detail B Pic.7 page.7) must be pulled.
Filter mounted in working
position
14 – BLADES ASSEMBLY AND DISASSEMBLY
Blades are easily removed unscrewing nut and screw (Detail. A) see the picture. To reassemble it, clean well and
tighten screws and nuts until they are fully secured, verifying that blades can be moved freely. Fixing nuts are self-
blocking type, so that is necessary replace them with new ones after its disassembling.
IMPORTANT!
Put the Flail Mower on a pallet after a good fastening and load it on a truck by a forklift.
Pic. 1
Pic. 2
15 - TRANSPORT
- 13 -
Filter ready to be extracted
Pic. 3
Hide quick links:
Advertisement
Table of Contents
