Akai MPCX User Manual page 125

If you set the Convert To field to New program with new
samples, this will create a new sample from each slice and assign
them to pads in a new program.
The new program will be named after the sample and appended
with ch. The new samples will be appended with SI-# (where # is a
consecutive number).
Check the Crop Samples box to delete the unused parts from
the sample when they are created and assigned. This feature is
destructive, though the project will still contain your original
sample.
Leave this box unchecked to keep the unused parts of the
samples when they're created and assigned. This way, you will
still be able to edit the entire samples further even though you
are using only part of them at the moment.
By default, this option already will create a new program. You
can uncheck the Create New Program box to convert each
slice into a sample that is placed in the project's sample pool
but not assigned to a program or pad.
If Create New Program is checked, check the Create Events
box to automatically create a new track in which each pad plays
its corresponding slice in ascending sequence by pad number.
If Create Events is checked, use the Bars field to set how
many bars the slices' events will occupy.
To convert the sample, tap Do It.
To cancel the operation, tap Close.
If you set the Convert To field to Assign slice to a pad, the pad
will simply refer to the slice in this sample instead of creating a new
sample. This is useful for reducing clutter in your project.
Important: Assigning a sample to a pad in this way will replace the
sample on the first layer of the pad.
Use the Pad field to select the desired pad. Alternatively, press
the desired pad.
Use the Slice Type field to select how the pad's layer settings
will be set when the slice is assigned to it (see
Mode to learn more about the parameters mentioned below):
•
Non-Destructive Slice: The pad's Slice setting will be set
to the slice number.
•
Pad Parameters: The pad's Slice setting will be set to Pad.
The Pad Start and Pad End will be set to the slice's start
point and end point values, and the Loop Position will be
set to the slice's start point but with Pad Loop deactivated.
Use the Program field to specify the program to which you
want to add the slice.
To convert the sample, tap Do It.
To cancel the operation, tap Close.
Program Edit
125