JVC DX-J36UN Service Manual page 18

3.2.4 Removing the motor board
(See Figs.9 and 10)
(1) From the top side of the DVD changer mechanism assem-
bly, remove the two belts from the motor pulleys. (See
Fig.9.)
Note:
Take care not to attach grease on the belt.
(2) Remove the two screws D attaching the motors to the load-
er assembly. (See Fig.9.)
(3) From the bottom side of the DVD changer mechanism as-
sembly, remove the two screws E. (See Fig.10.)
(4) Disconnect the connector
tray switch board and remove the motor board. (See
Fig.10.)
(5) Disconnect the card wire from the connector
forward side of the motor board. (See Fig.10.)
Note:
When connecting the card wire, let the card wire through the
slots h of the motor board. (See Fig.10.)
Reference:
You need not to remove the tray assemblies, and in such case,
move it.
3.2.5 Removing the motor
(See Fig. 10)
• Remove the motor board.
(1) From the reverse side of the motor board, unsolder the four
soldered sections i on the motor board.
(2) From the forward side of the motor board, remove the mo-
tors.
1-18 (No.MB666<Rev.005>)
CN2 on the motor board from the
CN1 on the
Belt
D
Motor
Motor pulleys
Fig.9
Motors
Motor board
Tray switch
board
E
CN2
CN1
h
DVD changer mechanism assembly
Fig.10
Belt
D
Motor
Loader assembly
i
Motor board
E
Motors