Makita 5740NB Instruction Manual page 10

CAUTION:
*Be sure the blade is installed with teeth pointing up
at
the front of the tool.
*Use only the Makita hex wrench to install or remove the blade.
*The inner flange has a 20 mm (13/16") diameter on one side and a 19 mm
(3/4")
diame-
ter on the other. The side with 19 mm (3/4") diameter is marked by "19". Use the correct
side for the hole diameter of the blade you intend to use. Mounting the blade on the
wrong side can result in dangerous vibration.
Inner flange
Mounting shaft
Outer flange
Hex socket head bolt
Blade
Fig. 1'
Adjusting depth
of
cut
Loosen the screw on the depth guide and
move the base up or down.
At the desired depth of cut, secure the
base by tightening the screw.
I
Fig. 11
CAUTION:
*Use a shallow depth of cut when cutting thin workpiece for cleaner, safer cuts.
*After adjusting the depth of cut, always tighten the screw securely.
10