RBS Installation Instructions
P018294B
Figure 1
4.1
Unpacking RBS
Unpack the RBS on-site. To avoid damage, the RBS must not be unpacked
elsewhere and then transported to site.
Ensure that the correct material has been delivered. If the material is damaged,
then complain immediately to the supervisor or the transport company.
4.2
Installing the RBS
This section describes how to install the RBS attached on a wall or to a ceiling.
Note: When installing, keep in mind the minimum required distances around
the RBS.
4
Unpacking the RBS
Installing the Wallplate
Attaching the RBS
Installing DC Power
Connecting Cables
Testing the Installation
Performing
Concluding Routines
Installation Flowchart
Installing the
Ceiling Bracket
Replacing Front
41/1531-LZA 701 0001 Uen D 2008-04-23