Sony MEX-M71BT Operating Instructions Manual page 12

Bluetooth
Hide thumbs Also See for MEX-M71BT:
Table of Contents

Advertisement

Available languages

Available languages

Connecting with a paired
BLUETOOTH device
To use a paired device, connection with this
unit is required. Some paired devices will
connect automatically.
1
Press MENU, rotate the control dial to
select [BLUETOOTH], then press it.
2
Rotate the control dial to select [SET
BT SIGNL], then press it.
Make sure that
3
Activate the BLUETOOTH function on
the BLUETOOTH device.
4
Operate the BLUETOOTH device to
connect to this unit.
or
lights up.
Icons in the display:
Lights up when handsfree calling is
available by enabling the HFP
(Handsfree Profile).
Lights up when the audio device is
playable by enabling the A2DP
(Advanced Audio Distribution
Profile).
To connect the last-connected device
from this unit
Activate the BLUETOOTH function on the
BLUETOOTH device.
To connect with the audio device, press SRC
to select [BT AUDIO] and press  (play/
pause).
To connect with the cellular phone, press
CALL.
Note
While streaming BLUETOOTH audio, you cannot
connect from this unit to the cellular phone.
Connect from the cellular phone to this unit instead.
Tip
With BLUETOOTH signal on: when the ignition is
turned to on, this unit reconnects automatically to
the last-connected cellular phone.
12
GB
lights up.
To install the microphone
For details, see "Installing the microphone"
(page 41).
Connecting with an iPhone/iPod
(BLUETOOTH Auto Pairing)
When an iPhone/iPod with iOS5 or later
installed is connected to the USB port, the
unit is paired and connected with the
iPhone/iPod automatically.
To enable BLUETOOTH Auto Pairing, make
sure [SET AUTOPAIR] in [BLUETOOTH] is set
to [ON] (page 26).
1
Activate the BLUETOOTH function on
the iPhone/iPod.
2
Connect an iPhone/iPod to the USB
port.
Make sure that
of the unit.
Notes
• BLUETOOTH Auto Pairing is not possible if the unit
is already connected to two BLUETOOTH devices.
In this case, disconnect either device, then
connect the iPhone/iPod again.
• If BLUETOOTH Auto Pairing is not established, see
"Preparing a BLUETOOTH Device" (page 10).
lights up on the display

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents