Setting The Timer's Activate Control - Philips 55PW9383 Directions For Use Manual

A
fter you have set the TIME, START
TIME, STOP TIME, and CHANNEL,
you must activate the Timer for it to operate.
Your options are to set the Timer to work
ONCE or DAILY. Set ACTIVATE to OFF if
you don't want to use the Timer.
1
Press the MENU/SELECT button
on the remote control to show the on-
screen menu.
2
Press the CURSOR RING DOWN
twice to highlight FEATURES.
3
Press the CURSOR RING RIGHT
to enter the FEATURES submenu.
4
Press the CURSOR RING RIGHT
again. Then press the CURSOR RING
DOWN repeatedly until the ACTI-
VATE control is highlighted.
5
Press the CURSOR RING RIGHT
to cycle through the options and make
your selection. The options are
ONCE, DAILY, or OFF.
6
Press the STATUS/EXIT button to
exit the menu.
H H
ELPFUL
• Changing the channel or adjusting the
volume during the last minute of a Timer
setting will cancel the shutting off of the
TV.
• Thirty seconds before the set changes to
the channel you set (see page 44), an
announcement appears on screen.
CHANGING TO
CHANNEL 5
IN 29 SEC
S T
ETTING THE IMER
6
INT
' A C
S CTIVATE ONTROL
PICTURE TIMER
SOUND AutoLock
FEATURES PIP
CLOSED CAP
INSTALL
FORMAT
POWER
3,4,
ACC
TV VCR
ACTIVE
SWAP PIP CH CONTROL FREEZE 5
DN UP
PICTURE
SOUND
MENU/
STATUS/
EXIT SELECT
MUTE
1
2
2
VOL CH
1 2 3
4 5 6
7 8 9
TV/VCR
0
A/CH
SURF
POSITION PIP
45
Using the On-screen Submenus: Features
FEATURES
TIMER TIME
AutoLock START TIME
PIP STOP TIME
CLOSED CAP CHANNEL
FORMAT ACTIVATE
FEATURES
TIMER
TIME 8:06 PM
START TIME
STOP TIME
CHANNEL
ACTIVATE
FEATURES
TIMER
TIME
START TIME
STOP TIME
CHANNEL
ACTIVATE ONCE
OR
ACTIVATE DAILY
OR
ACTIVATE OFF