Professional 2-way lcd remote car starter & alarm system with built in temperature, voltage sensor and two-way serial port data link (15 pages)
Summary of Contents for Auto Page RS-662
Page 1
RS-662 PROFESSIONAL REMOTE CAR STARTER & SECURITY / ALARM SYSTEM OPERATIONS MANUAL Please register your product at www.autopageusa.com THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY...
SYSTEM OPERATIONS: WARNINGS: As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while running on remote control. 3.
Page 3
CHANGING THE BATTERY IN YOUR TRANSMITTERS XT-33: This transmitter uses two (2) 3-volt lithium ion batteries (#CR2016) that are sandwiched together with the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to the key ring.
DEFECTIVE SENSOR REMINDER: If the siren sounds 3 chirps when arming, then you have left a door, trunk or hood lid ajar. SHOCK SENSOR / OPTIONAL SENSOR BY-PASS: Press the button once: The siren chirps once, the system is armed. Press the button a second time within 5 seconds: The siren chirps twice, the Shock Sensor is now bypassed.
Page 5
PATHWAY ILLUMINATION This feature turns the parking light “ON” for 30 seconds upon the unlock signal and for 10 seconds upon the lock signal. (Programmable) TWO STEPS DOOR UNLOCK: This feature will independently unlock the driver door only when deactivating the system. Pushing the button a second time within 3 seconds will unlock the entire vehicle.
DEACTIVATING WITHOUT A TRANSMITTER The Override function may be used if the remote transmitter is lost or inoperative. 1. Enter the vehicle and turn the ignition switch to ‘ON’ position. 2. Within 10 seconds push and release the valet switch when the in-dash LED stays on solid.
turn on alerting of an intrusion for 30 seconds. Then it will stop and automatic reset and re-arm. If one of the sensors or detectors is still active, the alarm system will sound a maximum of 6 times of 30 seconds cycles.
A. TO REMOTE START THE VEHICLE: When you want to start your vehicle, 1. Press button once on the transmitter. 2. The parking lights will flash to indicate the remote start received the signal. 3. The engine will start in approximately 5 seconds. 4.
times to confirm Temporary Stop feature ‘ON’ 2. Turn the ignition key to OFF position. (The engine will stay running.) 3. The engine will run until the pre-programmed time elapsed or shutdown input is received. TIMER START: You must fully understand this feature to operate the remote start safely.
After one (1) year, the purchaser should ship the unit prepaid to Auto Page with a money order in the amount of $30.00 to cover shipping and handling charges. Note: The product needs to be registered online at time of installation.
Page 11
OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Auto Page shall not be liable, under the foregoing WARRANTIES or otherwise, for: Any personal injury of any kind to the purchaser, its employees or agents or anyone else whomsoever resulting directly or indirectly from the use or presence of the equipment or parts;...
Page 13
960 Knox Street Unit B, Torrance, CA 90502 Tel: (310) 323-1800 or (800) 262-2527 www.autopageusa.com...