Page 1
USER MANUAL 600 // SLIDEOUT HOOD ARHS60X | ARHS60X-L IMPORTANT // Please ensure that you read through this user manual prior to installation and use. This manual contains important information to ensure optimal performance and keep you safe. Please retain your proof of purchase, as this will be required in the event that you require warranty service.
Page 2
HELLO CONGRATULATIONS ON THE SELECTION OF THIS SLIDEOUT RANGEHOOD. OUR APPLIANCES HAVE BEEN SPECIFICALLY DESIGNED FOR AUSTRALIAN AND NEW ZEALAND KITCHENS. Please read through this user manual carefully as it contains information that will ensure that your appliance is installed correctly, important operating &...
Page 3
HELLO CONTENTS WARNING & SAFETY INFORMATION INSTALLATION & DUCTING OPERATING INSTRUCTIONS MAINTAINING YOUR RANGEHOOD PRODUCT SPECIFICATION PROOF OF PURCHASE NOTES CONTACT DETAILS 600 // SLIDEOUT HOOD...
Page 4
WARNING & SAFETY INFORMATION This appliance is not intended for use The minimum distance between the by persons (including children) with hob surface and the lowest part of the reduced physical, sensory or mental rangehood is 600mm. This distance capabilities, or lack of experience and shall be at least 650mm, if the knowledge, unless they have been rangehood is installed over a gas hob.
Page 8
3-6 months depending on use. Your range hood is fitted with one of the following two different types of lamps accord- ingly to its model: Model Lamp Type ARHS60X 40W Halogen GU10 (x2) ARHS60X-L 3W LED GU10 (x2) 600 // SLIDEOUT HOOD...
Page 9
Motor: 2 x 100W Manufactured for Arisit Pty Ltd For service please call: Australia: 1300 815 589 New Zealand: 09 306 1020 600 SLIDEOUT HOOD MODEL: ARHS60X-L SERIAL: Lights: 2 x 3W 220-240V ~ 50HZ Total: 206W Motor: 2 x 100W...
Ph (09) 306 1020 FX (09) 302 0077 sales@aristonappliances.co.nz ARISTON IS COMMITTED TO ONGOING RESEARCH AND DEVELOPMENT. EVERY EFFORT HAS BEEN MADE TO ENSURE ALL INFORMATION IN THIS USER MANUAL IS CORRECT AT TIME OF GOING TO PRINT. DIMENSIONS SHOULD BE USED AS A REFERENCE ONLY AND ACTUAL DIMENSIONS SHOULD BE TAKEN FROM THE PHYSICAL PRODUCT ONLY.