Table of Contents
Advertisement
B
p
e
op
ad
diTor
M
in
Set a minimum value for the data.
M
ax
Set a maximum value for the data.
s
olo
Only sends the data from the corresponding modline. Useful for MIDI mapping in DAWs and other
music software. This is set to off on power cycle, or a preset load.
l
v
ive
alUe
The real-time value of the source. Helpful for fine tuning the response of a sensor to a desired range
or destination.
Even though you can monitor the updates in real time, you still need to
save and send the preset to the BopPad for the preset to be stored onto
the device.
5.1.5 T
d
he
eviCe
The Device Settings section contains settings that influence the overall behavior of your BopPad.
•
Unison Mode - Makes BopPad function as one quadrant (all four quadrants use the settings for the
selected Unison Quadrant). Any quadrant can be the Unison quadrant by selecting that quadrant
and clicking on the Unison button.
•
All Quadrant Mode - Allows you to edit the note values, modline values, and quadrant settings for
all four quadrants at the same time.
s
eTTings
B
p
op
ad
15
Advertisement
Table of Contents
