Ezset PMR30S31 User Manual

Pmr electronic lock

Advertisement

封底
封面
148.5 x 210(mm)
www.ezset.com.tw
PMR ELECTRONIC LOCK
USER GUIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PMR30S31 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ezset PMR30S31

  • Page 1 封底 封面 148.5 x 210(mm) www.ezset.com.tw PMR ELECTRONIC LOCK USER GUIDE...
  • Page 2: Parts Introduction

    封面裡 Installation Procedures Do not use an electric screwdriver Parts Introduction (In all illustrations a right-hand door is the example) when installing the product ! 1. Draw horizontal lines on the door and Latch center door edge line Measure for the lever center line on the door and door edge 36"...
  • Page 3: Strike Installation

    6. Lock Case Installation 5. Strike Installation Upper wire exit hole 1. Swing the door almost closed up to the door jamb and draw the latch center line on the 1. First, insert the upper and lower IC wires door jamb to match the latch center line on the door. into the door's groove and then pull them 2.
  • Page 4: Cylinder Installation

    9. Cylinder Installation 6.First pull the IC wire through the upper wire exit hole to the room side and then insert the 1.Fasten the lock cylinder clockwise into the threaded latch so that the surface of the lock exterior spindle of the exterior lock body into the square hole that corresponds to the latch cylinder is flush with the edge, with the keyhole located at the 6 o'clock position.
  • Page 5 10. Door Handing Determination 2. Keep the interior lever horizontal as illustrated, aim the square hole at the interior spindle. Interior Lock Body Regardless whether the door opens inward or outward, you should take "the exterior side of Meanwhile, point the turn piece stem to the the door"...
  • Page 6: Setup Description

    Setup Description Low-battery Card Sensing Area Indicator Status Indicator Entry Prohibition Indicator Mode Switch – Automatic Battery Cover Locking/General Thumb Turn Password Card Learn Learn Button Button Hidden Touch Start Button Keypad Area Keyhole...
  • Page 7: Setup For Use

    Setup for Use 3.Erasing All Cards and Passwords 1. Hold down the Card Learn Button (right). 2. A beep will sound. Before the first time you use it, please erase all cards and passwords prior to use to assure 3. Release the button after hearing 2 beeps five times at 2 seconds intervals following by that all cards are authorized by you.
  • Page 8 9.Low Battery Alert Opening from the inside As the battery power falls below a certain level, a long beep is emitted after every locking Simply turn the lever to unlock. or unlocking, and the Low Battery indicator (red) on the upper left corner of the panel lights up, indicating a low battery level.
  • Page 9: Troubleshooting

    Q&A Q&A Troubleshooting Troubleshooting I always hear 5 beeps after each operation and the indicator Why would the numbers "1" and "7" on the keypad light up and the keypad become nonfunctioning when using the password to unlock in the middle flashes a yellowish red light. What does it mean? the door? If this problem continues, please contact the distributor for assistance as This occurs because the process took too long.

Table of Contents