Processor; User Interface; Inputs & Outputs; Power Supply Specifications (Absorption / Installation) - dB Technologies SIGMA S218 User Manual

PROCESSOR

Internal controller:
Limiter:

USER INTERFACE

Controls:
INPUTS & OUTPUTS
Inputs:
Outputs:

POWER SUPPLY SPECIFICATIONS (ABSORPTION / INSTALLATION)

Absorption at 1/8th of power in
medium use conditions (*):
Absorption at 1/3rd of power in
maximum use conditions (**):
Full-power rated
absorption (**):
Absorption with speaker on in
no-signal condition (idle):
Inrush current:
Total current and power allowed in a
daisy-chained system (***):
* NOTE FOR INSTALLER: Values refer to 1/8th of power, under average operating conditions (music programme with occasional or no
clipping). For any type of configuration we recommend to consider them as minimum sizing values.
** NOTE FOR INSTALLER: Values refer to 1/3rd of power, under heavy operating conditions (music programme with frequent clipping and
limiter activation). In case of professional installations and tours we recommend sizing according to these values.
** Laboratory value obtained using a continuous sine-wave signal
SIGMA S218
34
Subwoofer level, Subwoofer setup (Delay, Polarity), Xover, Outputs Mode
2 x XLR Balanced Inputs
2 x XLR Balanced Outputs
2.45 A / 290 W (220-240V~) - 4 A / 290 W (100-120V~)
5.25 A / 680 W (220-240V~) - 8.57 A / 660 W (100-120V~)
6 A (220-240V~) - 12 A (100-120V~)
10 A / 2300 W (220-240V~) - 3 A / 330 W (100-120V~)
28-bit/56-bit DSP
Peak, RMS, Thermal
41 W
88.67 A
Cod. 420120258 REV. 1.0
English