Table of Contents
Advertisement
Step 5
a)
Put the oil plate (I) above the burner and align
the holes with the holes on the side hole of the
body.
b)
Insert one bolt (GGG) into each pre‐drilled hole
and seal with one flat washer (DDD) and one
spring washer (EEE), and one nut (FFF).
c)
Tighten the bolts by the screwdriver (NNN).
Step 7
a)
Align the holes on the bottom of the body
with the holes on the body support‐L (N) and
the body support‐R (Q).
b)
Insert one bolt (III) into each pre‐drilled hole
and seal with one body insulation cushion (R).
c)
Tighten the bolts by the screwdriver (NNN).
d)
Insert the Ignition cable to the valve.
Step 6
a)
Align the holes on the body support‐L (N) and
the body support‐R (Q) with the holes on
connecting plate (P).
b)
Insert one bolt (HHH) into each pre‐drilled
hole and seal with one flat washer (AAA) and
one spring washer (BBB).
c)
Put the grease cup (O) onto the connecting
plate (P).
d)
Tighten the bolts by the screwdriver (NNN).
9
Advertisement
Table of Contents
