Table of Contents
Advertisement
Step 1
a) Inset the thermometer (B) into the holes on
the front top of the lid (A) and seal with the
thermometer flat washer (KKK) and the
thermometer nut (JJJ).
b) Insert the pre‐attached bolts on the lid handle (D)
into the holes on the front bottom of the lid and seal
with one flat washer (AAA), one spring washer
(BBB), and one nut (CCC).
c) Tighten the nuts by the wrench (OOO).
Step 3
a)
Align the holes on the back side of body (M) with
the holes on the BODY GEMEL‐L (K) and the BODY
GEMEL‐R (L).
b)
Insert one bolt (GGG) into each pre‐drilled hole
and seal with one flat washer (DDD) and one
spring washer (EEE).
c)
Align the holes on the bottom of body (M) with
the holes on the burner support (J).
d)
Insert one bolt (GGG) into each pre‐drilled hole
and seal with one flat washer (DDD) and one
spring washer (EEE), and one nut (FFF).
e)
Tighten the bolts by the screwdriver (NNN).
Step 2
a)
Align the holes on the back side of lid with the
holes on the LID GEMEL‐L (E) and the LID
GEMEL‐R (F).
b)
Insert one bolt (GGG) into each pre‐drilled hole
and seal with one flat washer (DDD) and one
spring washer (EEE).
c)
Tighten the bolts by the screwdriver (NNN).
Step 4
b)
Align the hole on the burner support (J) with
the hole on the burner (H). Through the
burner head out from the side hole of the
body.
c)
Insert one bolt (HHH) into the pre‐drilled
holes and seal with one flat washer (AAA) and
one spring washer (BBB).
d)
Tighten the bolt by the screwdriver (NNN).
8
Advertisement
Table of Contents
