Makita 3707 Instruction Manual page 6

Templet guide
001703
The templet guide provides a sleeve through which the
bit passes, allowing use of the trimmer with templet
patterns.
Loosen the screws and remove the base protector. Place
the templet guide on the base and replace the base
protector. Then secure the base protector by tightening
the screws.
2
1
001704
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
10mm (3/8")
001988
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the router bit and the outside of the
templet guide. The distance (X) can be calculated
by using the following equation:
Distance (X) = (outside diameter of the templet guide -
router bit diameter) / 2
1. Screws
2. Base protector
3
3. Screwdriver
1
1. Straight bit
6
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide
5
10
Straight guide (Accessory)
001706
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Attach the guide plate to the straight guide with the bolt,
the wave washer, the flat washer and the wing nut.
1
2
3
4
001990
Attach the straight guide with the clamp screw (A).
Loosen the wing nut on the straight guide and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing nut securely.
1
2
3
001708
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
If the distance (A) between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a straight
board to the workpiece and use it as a guide against the
trimmer base. Feed the tool in the direction of the arrow.
6
1. Bolt
2. Guide plate
3. Straight guide
4. Wing bolt
1. Clamp screw (A)
2. Straight guide
3. Wing nut
4. Base
4