Pentair Pool Products Warrior Owner's Manual

Pentair Pool Products Warrior Owner's Manual

D.e. filter system

Advertisement

D.E. Filter System Owner's Manual
IMPORTANT SAFETY INSTRUCTIONS
SECTION II.
SECTION III.
SECTION IV.
SECTION V.
SECTION VI.
SECTION VII
SECTION VIII.
SECTION IX.
SECTION X.
SECTION XI.
Before installing this product, read and follow all warning notices and instructions accompanying this
filter. Failure to follow safety warnings and instructions can result in severe injury, death, or property
damage. Call 1-800-831-7133 for free copies.
1620 Hawkins Ave., Sanford, NC 27330 (919) 774-4151
10951 West Los Angeles Ave., Moorpark, CA 93021 (805) 523-2400
Rev. F 6/15/06
Rev. F 6/15/06
Warrior

Table of Contents

PUMP SAFETY INSTRUCTIONS.............................................2
HOW YOUR FILTER WORKS.................................................3
INSTALLATION..................................................................4
CLEANING THE FILTER........................................................7
WINTERIZING THE FILTER...................................................10
TROUBLESHOOTING..........................................................11
PUMP INSTRUCTIONS.........................................................11
TECHNICAL DATA.............................................................13
WARNING
1
1
P/N 99101200
P/N 99101200

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Warrior and is the answer not in the manual?

Questions and answers

Summary of Contents for Pentair Pool Products Warrior

  • Page 1: Table Of Contents

    Failure to follow safety warnings and instructions can result in severe injury, death, or property damage. Call 1-800-831-7133 for free copies. Pentair Pool Products, Inc. 1620 Hawkins Ave., Sanford, NC 27330 (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 (805) 523-2400 READ AND FOLLOW ALL SAFETY INSTRUCTIONS Rev.
  • Page 2: Read And Follow All Instructions

    SECTION I. PUMP SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: 1. READ AND FOLLOW ALL INSTRUCTIONS. 2. WARNING - To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times.
  • Page 3: Section Ii. How Your Filter Works

    WARNING THIS FILTER OPERATES UNDER HIGH PRESSURE. WHEN ANY PART OF THE CIRCULATING SYSTEM (e.g. LOCK RING, PUMP, FILTER VALVES, ETC.) IS SERVICED, AIR CAN ENTER THE SYSTEM AND BECOME PRESSURIZED. PRESSURIZED AIR CAN CAUSE THE LID TO BE BLOWN OFF WHICH CAN RESULT IN SEVERE INJURY, DEATH, OR PROPERTY DAMAGE.
  • Page 4: Section Iii. Installation

    WARNING Failure to operate your filter system or inadequate filtration can cause poor water clarity obstructing visibility in your pool. Pool water clarity may obscure objects in the water, which while swimming and diving could cause severe personal injury and death. Never swim in a pool with poor water clarity. SECTION III.
  • Page 5 10. Install the High Flow air relief valve to the top of the tank lid. See Diagrams 2 and 3, Detail A. This is an O-ring seal that requires hand tightening only. 11. Install the pressure gauge in the ¼”NPT threaded hole in the tank lid, using Teflon tape on the threads.
  • Page 6: Initial Start-Up And Restart Instructions

    SECTION IV. INITIAL START UP AND RESTART INSTRUCTIONS. 1. Be sure all connections have been made and are secure. 2. Make sure the hair and lint pot of the pump is filled with water. (FAILURE TO FILL THE HAIR AND LINT POT WITH WATER WILL RESULT IN DAMAGE TO THE PUMP AND PUMP SEAL).
  • Page 7: Section V. Cleaning The Filter

    WARNING THIS FILTER OPERATES UNDER HIGH PRESSURE. WHEN ANY PART OF THE CIRCULATING SYSTEM (e.g. LOCK RING, PUMP, FILTER, VALVES, ETC.) IS SERVICED, AIR CAN ENTER THE SYSTEM AND BECOME PRESSURIZED. PRESSURIZED AIR CAN CAUSE THE LID TO BE BLOWN OFF WHICH CAN RESULT IN SEVERE INJURY, DEATH, OR PROPERTY DAMAGE.
  • Page 8 12. Clean any debris from the O-ring at the top of the filter tank. Apply a silicone lubricant to the O-ring. DO NOT USE A PETROLEUM-BASE LUBRICANT ON THE O-RING. Failure to properly clean and lubricate the O-ring may result in water leakage. 13.
  • Page 9: Check Valve Installation Instructions

    SECTION VI. CHECK VALVE INSTALLATION INSTRUCTIONS WARNING THIS FILTER OPERATES UNDER HIGH PRESSURE. WHEN ANY PART OF THE CIRCULATING SYSTEM (e.g. LOCK RING, PUMP, FILTER VALVES, ETC.) IS SERVICED, AIR CAN ENTER THE SYSTEM AND BECOME PRESSURIZED. PRESSURIZED AIR CAN CAUSE THE LID TO BE BLOWN OFF WHICH CAN RESULT IN SEVERE INJURY, DEATH, OR PROPERTY DAMAGE.
  • Page 10: Section Vii. Winterizing The Filter

    11. With the High Flow manual air relief valve in the open position, start the pump, after a steady stream of water appears close the High Flow manual air relief valve. 12. Your system is now in operating order. SECTION VII. WINTERIZING THE FILTER 1.
  • Page 11: Section Ix. Trouble Shooting

    SECTION IX. TROUBLE SHOOTING PROBLEM CAUSE REMEDY Pool water not 1. Pool chemistry not adequate to inhabit algae growth. Maintain pool chemistry or consult pool service technician. sufficiently clean. 2. Inadequate turnover rate. Run system for longer time or consult dealer or pool service technician.
  • Page 12 2. TO CLEAN THE BASKET – (pump must be off) a. Follow the instructions above to prime the pump. b. After removing the lid, remove the basket and empty the debris. c. Replace the basket and proceed to fill the pot with water. d.
  • Page 13: Section Xi. Technical Data

    SECTION XI. TECHNICAL DATA FILTER AND BASE – REPLACEMENT PARTS Warrior D.E. Filter Replacement Parts Item Part Number Description Quantity 98209800 High Flow Manual Relief Valve 53003201 Pressure Gauge Lid, 44 GPM Filter, Black 59053200 190041 Lid, 44 GPM Filter, Almond...
  • Page 14: Read And Follow All Safety Instructions

    Dynamo PUMP REPLACEMENT PARTS Item Part Number Description Quantity 356597 Motor, 1HP SPL, 1 Phase, 60 Hz, 115V 356595 Motor, 1 1/2HP SPL, 1 Phase, 60Hz, 115V 356469 Motor, 2HP SPL, 1 Phase, 60Hz, 115V 354632 Bracket, Diffuser, 3/4HP 354633 Bracket, Diffuser, 1HP, 1 1/2HP 354542 Square Nut No.
  • Page 15: Read And Follow All Safety Instructions

    OptiFlo PUMP REPLACEMENT PARTS Item Part Number Description Quantity 154699 Drain Plug 354545 Mechanical Seal 354552 Impeller 3/4HP, 1HP SPL 350017 Impeller 1 1/2HP SPL 192115 O-Ring, Drain Plug 357213 Volute 357255 O-Ring @-357 357227 357228 357239 Clamp, Cam & Ramp 357254 Square Nut, ¼-20 Stainless Steel 355667...
  • Page 16: Read And Follow All Safety Instructions

    CSA ENCLOSURE REPLACEMENT PARTS MOTOR BOLTS (4) Item Part Number Description Quantity 354621 Body, Motor Enclosure 354881 Cap, Motor Enclosure 154716 Screw, No 10 Self Tapping 155371 Cord Assy, 25’ Long With Standard Plug and Plastic Bushing (P/N41412700) 155187 Switch, On/Off Toggle (CSA) 155193 Wire, 6”...
  • Page 17 NOTES Rev. F 6/15/06 P/N 99101200...
  • Page 18 NOTES Rev. F 6/15/06 P/N 99101200...
  • Page 19: Pentair Pool Products, Inc

    This page is blank. Pentair Pool Products, Inc. 1620 Hawkins Ave., Sanford, NC 27330 (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 (805) 523-2400 READ AND FOLLOW ALL SAFETY INSTRUCTIONS Rev. F 6/15/06 P/N 99101200 Rev. F 6/15/06...
  • Page 20: Pentair Pool Products, Inc

    SAVE THESE INSTRUCTIONS Pentair Pool Products, Inc. 1620 Hawkins Ave., Sanford, NC 27330 (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 (805) 523-2400 READ AND FOLLOW ALL SAFETY INSTRUCTIONS Rev. F 6/15/06 P/N 99101200 Rev. F 6/15/06 P/N 99101200...

Table of Contents