Table of Contents
Advertisement
3.1.3 Removing the front panel assembly (See Figure 5, Figure 6, Figure 7)
• Prior to performing the following procedure, remove the top
cover and mechanism assembly.
(1) Disconnect the card wire from connector
board.
(2) Hook b and c are removed respectively, and the front panel
assembly is removed.
(3) Remove the three screws D attaching the FL display board.
(4) Disconnect the card wire from connector
display board.
3.1.4 Removing the rear panel (See Figure 8)
• Prior to performing the following procedure, remove the top
cover.
(1) Remove the eight screws E attaching the rear panel.
(2) Remove the power cord bushing.
CN3
on the power
CN801
on the FL
Front panel assembly
Front panel assembly
Fig.5
Hook c
Hook c
Front panel
assembly
Hook c
Hook b
Fig.6
FL Display board
D
CN801
Fig.7
E
Fig.8
CN3
Power board
Hook b
D
Bushing
E
(No.YD016)1-9
Advertisement
Table of Contents
