Ford FOCUS Owner's Manual page 59

Hide thumbs Also See for FOCUS:
Table of Contents

Advertisement

WARNINGS
Check and replace wiper blades
regularly to ensure the camera
sensor has a clear view through the
windscreen. Replacement wiper blades
must be the correct length.
Note: Keep the windscreen free from
obstructions such as bird droppings, insects
and snow or ice.
Note: Reflective road signs may be
detected as oncoming traffic and the
headlamps will be switched to low beam.
Note: Always fit Ford Original Parts when
replacing headlamp bulbs. Other bulbs may
reduce system performance.
The system will automatically switch on
high beams if it is dark enough and no other
traffic is present. If it detects an
approaching vehicle's headlamps or tail
lamps, or street lighting ahead the system
will switch off high beam before it can
distract other road users. Low beam will
remain on.
A camera sensor is centrally mounted
behind the windshield of your vehicle. This
monitors conditions continuously to decide
when to switch the high beams on and off.
Once the system is active the high beam
will switch on if:
It is dark enough to require the use of
high beams and
there is no traffic or street lighting
ahead and
vehicle speed is greater than 40 km/h.
The high beam will switch off if:
The rear fog lamps are switched on.
The ambient light is high enough that
high beam is not required.
An approaching vehicle's headlamps
or tail lamps are detected.
Street lighting is detected.
Focus (CF3) Australia/New Zealand, Vehicles Built From: 15-06-2015, F1EB-19G219-ZAA / F1EB-19G219-ZDA enAUS, Edition date: 05/2015, First Printing
Lighting
Vehicle speed falls below 30 km/h.
The camera sensor is too hot or
becomes blocked.
Activating the System
Switch the system on using the information
display. See Information Displays (page
73). Turn the switch to the autolamps
position. See Autolamps (page 55).
E142451
The Automatic High Beam Control
indicator will illuminate to confirm when
your system is ready to assist.
Manually Overriding the System
E169254
Push or pull the lever to switch between
high and low beam.
57

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents