Cabela's 541836 Warning & Instruction Booklet page 6

Fig. 2
M8 X 55 BOLT
ATTACH CHIMNEY AND CHIMNEY CAP
1. Install chimney to grill as shown in Fig 3. Make sure to install
the gasket between the grill and the chimney.
2. Tighten all hardware.
3. Install M6 x 76 Bolt through chimney cap and secure using Qty
(1) M6 nut. Thread second nut onto bolt leaving approximately
1.5" to the top of the cap. Thread cap assembly down into the
chimney bracket until the lower nut hits the bracket. See Fig 3.
4. The height of the chimney cap can be adjusted for summer and
ASH CUP
winter. In the summer the gap should be approximately 1-1/2". In
the winter the gap should be approximately ½".
5. Tighten all hardware.
Fig. 3
M6 X 76 BOLT
M6 NUT
M6 X 15 SCREW
CHIMNEY GASKET
INSTALL HANDLE
1. Install the handle as shown in Fig. 4.
2. Tighten all hardware.
Fig. 4
INSTALL SHELF
1. Install shelf as shown in Fig 5.
2. Tighten all hardware
M6 X 15 SCREW
M8 FLANGE NUT
M6 X 15 SCREW
GREASE BUCKET
1. Hang grease bucket from tube as shown in Fig 5.
ASH CUP
1. Install Ash Cup as shown in Fig 6. Never use grill without Ash
Cup in place.
HEAT DEFLECTOR AND DRIP TRAY
1. Install the Heat Deflector and Drip tray as shown in
Fig7 and Fig 8.
M6 FLAT WASHER
M6 LOCK WASHER
M6 NUT
Fig. 7
Fig. 8
WARMING RACK AND COOKING GRATE
1. Install the Warming Rack and Cooking Grate as shown in Fig. 9
Fig. 5
M6 X 15 SCREW
GREASE BUCKET
Fig. 6
ASH CUP
DRIP TRAY
HEAT DEFLECTOR
DRIP TRAY
HEAT DEFLECTOR
CLEANOUT PO