Cadillac CTS Owner's Manual page 60

2. Adjust the driver seat, outside
mirrors, and the power tilt and
telescoping steering column (if
equipped) to the desired
positions.
3. Press and release SET. A beep
will sound.
4. Immediately press and hold 1
until two beeps sound.
5. Repeat Steps 1 and 2 for a
second driver using 2.
Repeat Steps 1 4 using
your positions for getting out of the
vehicle.
Manually Recalling Memory
Positions
Press and hold 1, 2, or
manually recall the previously stored
memory positions. Releasing 1, 2,
or before the stored positions are
reached stops the recall.
Automatically Recalling Memory
Positions
If programmed in vehicle
personalization, the Auto (Automatic)
Memory Recall feature automatically
recalls the current driver's previously
stored 1 or 2 position when the
ignition is changed from off to ON/
RUN/START or ACC/ACCESSORY.
The transmission must be in P (Park).
See Vehicle Personalisation 0 145.
To stop recall movement, press one of
the memory, driver seat, outside
mirror, or power tilt and telescoping
steering column controls.
RKE transmitters are not labelled with
a number. If your memory seat
to store
position is stored to 1 or 2 but this
position is not automatically recalling,
then store your positions to the other
button or switch RKE transmitters
with the other driver.
If the vehicle's driver has changed, in
to
some vehicles the Driver ID may be
displayed for the first few ignition
cycles.
Easy Exit Recall
If programmed on in the vehicle
personalisation menu, the Easy Exit
feature recalls the previously stored
(Exit) positions when leaving the
SEATS AND RESTRAINTS
vehicle. See Storing Memory
Positions listed previously. See also
Vehicle Personalisation 0 145.
Easy Exit Recall automatically
activates when one of the following
occurs:
The vehicle is turned off and the
driver's door is opened within a
short time.
The vehicle is turned off with the
driver's door open.
Obstructions
If something has blocked the driver
seat and/or the power tilt and
telescoping steering column while
recalling a memory position, the recall
may stop. Remove the obstruction.
Then do one of the following:
If automatically or manually
recalling the stored memory
position, press and hold the
appropriate manual control for
two seconds. Try recalling again
by pressing the appropriate
memory button, then try recalling
again by opening the driver door
and pressing on the RKE
transmitter.
59