Page 1
Owner Instructions Original Instructions Warning! Read instructions before using the machine HVB 160 Henry / HEB 160 Hetty Numatic Lithium-Ion Battery Powered www.numatic.com...
Page 2
Kit - AS29E NOTE* Located in the bottom of your box is your Lithium-Ion Battery and charger Assembly...
Operating your machine for the first time Your Battery will arrive in transportation mode. It is not possible to operate your Henry, until the battery is first placed on the charger. It is recommended that a battery is fully charged before first use. Using your machine 2 Speed Switch CLICK...
Page 4
Using your machine Wand docking Tool Tidy...
Page 6
Fitting the Face on CLICK CLICK Removing the Face CLICK...
Page 7
About your machine Rating Label Voltage Power rating Weight (ready to use) Company Name & Address Machine Description Machine yr/wk Serial number WEEE Logo CE Mark (personal protective equipment) That may be required for certain operations. Ear Protection Safety Footwear Head Protection Safety Gloves Eye Protection...
Page 8
If the vacuum cleaner stops working, remove the battery from the machine before investigating where the fault lies. Failure to rectify the problem or in the event of a breakdown contact your Numatic dealer or the Numatic Technical helpline +44 (0)1460 269268.
Page 9
Important Warnings – Batteries Read all the warnings before using the battery. This cleaner uses Numatic Lithium-Ion batteries. Used batteries should be disposed of safely and placed in a sealed plastic bag and then handled according to all locally approved precautions and environmental regulations.
Page 10
In case battery is subject to environmental conditions outside the above parameters user must allow at least 3 hours for battery to acclimatise at room temperature before attempting to operate. If the battery is found to be faulty at any time, contact Numatic International, or World Wide Lithium-Ion Battery Technical Helpline +1-703-741-5970...
Charging the machine CLICK Charger Status Indications The charger is equiped with a double colour LED’s to indicate the status of the charger and battery. CHARGE INDICATOR STATUS Green Continuously On Charge Complete Green Flashing Without Pause Charger in Standby Red Continuously On Charging Red Flashing Without Pause...
Page 12
The battery included in this product must only be charged by the Numatic Charger supplied with the product under NO circumstances should an alternative non Numatic charger be used as there is risk severe damage and fire could result. Only use genuine Numatic parts. Instructions for Use – Charging Batteries The charger is intended for use only on flat surfaces, place horizontally on floor or work suface.
Lo = >30 mins Sound Pressure Size Hi = 64.5 dB (A) 315 x 340 x 345 mm Lo = 62.6 dB (A) Uncertainty 0.5 dB For best performance make sure you use genuine Numatic bags 604015 NVM-1CH (pack of 10)
Page 14
Schematic Diagram DRW-21326 (A06) Declaration of conformity...
Page 15
Lithium - Ion Battery Warranty. Numatic International will guarantee your Numatic Lithium - Ion battery for 500 recharging cycles, providing the cycles have been carried out to the manufacturer’s specifications and requirements. Failure to use the correct Numatic charger will void your warranty.
Need help?
Do you have a question about the HVB 160 henry and is the answer not in the manual?
Questions and answers