sunjoe SWJ805E Operator's Manual page 8

2. Remove the cutting bar and chain from the mounting
surface (Fig. 3).
Fig. 3
Chain
3. Remove the old chain from the bar.
4. Lay out the new saw chain in a loop and straighten
any kinks. THE SHARP SIDE OF THE TEETH MUST
FACE AWAY FROM YOU IN THE DIRECTION OF THE
CHAIN ROTATION INDICATED ON THE GUIDE BAR
. If the teeth face backwards,
turn the loop over (Fig. 4).
Fig. 4
Sharp cutting edge
Chain drive link
5. Starting at the tip, mount the chain drive links into the
bar groove, leaving a loop at the back of the bar. The
chain will loosely fit until it is placed on the sprocket
(Figs. 5 & 6).
NOTE: Make certain of the direction of the chain
.If the chain is mounted
backwards, the saw will vibrate abnormally and will not cut.
Fig. 5
Fig. 6
Cutting bar
Loop
R
6. Hold the chain in position on the bar and place the loop
around the sprocket. Fit the bar flush against the mounting
surface so that the bar studs are in the long slot of the bar
and the adjusting pin is in the chain tension pin hole
(Fig. 7).
Fig. 7
Chain rotation
7. Adjust the chain tension as needed by adjusting the chain
tensioner screw with the supplied M5 hex key wrench.
Make sure to align the chain tensioner screw with the
pin hole (Fig. 8).
Fig. 8
8. Replace the chain/sprocket end cover. Tighten the end
cover nut, but leave the bar free to move for tension
adjustment.
8
Chain tension pin hole
(with adjusting pin)
Sprocket Bar studs
Chain
tensioner
screw
M5 hex key wrench
R