Hazard Warning Lights; Replacing A Bulb - Alfa Romeo Giulia 952 D-SEDAN 2016 Owner's Handbook Manual

HAZARD WARNING LIGHTS

CONTROL
48)
Press the fig. 118 button to switch the
hazard warning lights on/off.
When the hazard warning lights are on,
the and warning lights flash.
When you need to move away from the
vehicle to look for help, the hazard
warning lights will continue flashing even
if the ignition device is in the STOP
position.
118
IMPORTANT The use of hazard warning
lights is governed by the highway code of
the country you are driving in: comply
with legal requirements.
122
Emergency braking
The hazard lights are switched on and
warning lights
instrument panel in case of emergency
braking and according to the mode
selected by the "Alfa DNA™" selector.
When the "Alfa DNA™" selector is in
position "n" or "a", the activation
threshold of the hazard warning lights is
higher; on the other hand, in position "d"
the sensitivity of the activation is lower
than that in the "n" and "a" modes.
The lights switch off automatically when
emergency braking ceases.
IMPORTANT
48) A prolonged use of the hazard warning
lights may discharge the battery.
08016S0001EM

REPLACING A BULB

and appear on the
GENERAL INSTRUCTIONS
contacts for oxidation;
same type and power;
always check its alignment;
the corresponding fuse is intact before
changing the bulb. For the location of
fuses, refer to the paragraph "If a fuse
blows" in this chapter.
IMPORTANT In some particular climate
conditions such as low temperature,
humidity or after washing the car, a thin
condensation layer may form on the
internal surfaces of the front and rear
headlights. This phenomenon will
disappear after switching on the
headlights
119) 120) 121)
49)
Before replacing a bulb check the
replace blown bulbs with others of the
after replacing a headlight bulb,
when a light is not working, check that