Digital Tuner; General Operation; Tuning To Radio Stations - Philips AZ 2425/17 User Manual

OPERATION

GENERAL OPERATION

1. To switch on the set, press the POWER button.
2. To select your sound source press the CD TAPE TUNER button
until the desired mode is shown in the display.
3. Adjust the volume using the VOLUME 3, 4 buttons.
™ Display indication shows the level, 0-32 and VOL.
4. Adjust the sound effect by pressing the DSC button once or
more.
™ DBB, JAZZ or POP lights up when activated.
5. Create an enhanced surround sound by pressing the
INCREDIBLE SURROUND button.
™ The INCREDIBLE SURROUND button lights up when
activated.
6. To switch off the set, press the POWER button to the off
position.
Note:
When the set is switched off:
– The last source selected and tuner presets will be retained in
the set's memory
– the volume will automatically adjust to level 12.

TUNING TO RADIO STATIONS

1. Press the CD TAPE TUNER button repeatedly until the TUNER
mode is displayed.
™ tU appears briefly on the display to indicate that you have
entered the tuner mode.
2. Press BAND to select your wave band.
To tune to radio stations, press the TUNING control ∞ or §
on the set until the frequency on the display starts running,
before releasing your finger from the control.
™ The radio automatically tunes to a station of sufficient
reception and Srch appears on the display.
3. Repeat if necessary until you find the desired station.
– To tune to a weak transmitter, briefly press TUNING ∞ or §
until you have found optimum reception or the correct
frequency is shown on the display.
– When STEREO appears on the display, you are receiving a FM-
stereo transmitter.
To improve radio reception:
– For FM, pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close
to a transmitter).
– For AM, the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
10

DIGITAL TUNER

SE N SO R
SE N SO R
CD TAPE
FM
STEREO
TUNER