Page 1
Portable CD Mini System Toll Free Help Line Ligne d'assistance en service libre Linea de ayuda telefónica sin cargo 800-531-0039 TUN ER TUN ER TAP E TAP E PRO G PRO G STO P STO P SEA RCH SEA RCH PLA Y/PA USE PLA Y/PA USE BAN D...
Page 2
TUN ER TAP E PRO G STO P SEA RCH PLA Y/P AU SE BAN D – – SPEAKERS 4 MAINS & for AZ 2765 model only...
Page 3
CONTROLS TOP AND FRONT PANELS 1 POWER - ON/OFF switch 2 DBB (Dynamic Bass Boost) - to enhance 3 VOLUME - to adjust volume level 4 CD, TUNER, TAPE - to select the source of sound 5 REMOTE SENSOR - for the remote control (for AZ 2765 model only) 6 CD Display - to show the CD functions 7 OPEN - to open/ close the CD door...
Whenever convenient, use the power supply if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries. BATTERIES (OPTIONAL) 1. Open the battery compartment and insert six batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity as indicated by the "...
SPEAKERS REMOVABLE LOUDSPEAKERS Taking off the speakers Keep the lever (found on the back corner of the speaker) pressed and slide the speaker upwards. Attaching the speakers Slide the speakers from above into the sleeves on the sides of the cabinet.
TUNING TO RADIO STATIONS 1. Press POWER to on position. 2. Press TUNER source button. – The TUNER indicator lights up. 3. Press BAND once or more to select the desired FM/ AM waveband. 4. To tune to a radio station press SEARCH ¡ or ™ for more than 1 second and release when the frequency in the display starts to change.
Page 7
CD PLAYER DISPLAY INDICATION FOR CD FUNCTIONS CD door open CD inserted – In stop mode total track number and total playback time – During CD playback elapsed playback time of current track and current track number – PAUSE elapsed playback time freezes and flashes PROGRAM when you program a selected track number program cancelled/ PROG pressed for more...
Page 8
PLAYING A CD 1. Press POWER to on position. 2. Press CD source button. – The CD indicator lights up. 3. To open the CD door, press OPEN on the CD door. 4. Insert a CD with the printed side facing up and press the CD door gently to close.
CD PLAYER DIFFERENT PLAY MODES : SHUFFLE AND REPEAT The SHUFFLE and REPEAT buttons allow you to select various play modes. The modes can be selected or changed during playback. SHUFFLE - all tracks are played in random order REPEAT - plays the current track continuously REPEAT ALL - repeats the entire CD 1.
CASSETTE RECORDER PLAYING A CASSETTE 1. Press POWER to on position. 2. Press TAPE source button. – The TAPE indicator lights up. 3. Press STOP•EJECT 9/ to open the cassette holder and insert a cassette. 4. Press the cassette holder shut. 5.
RECORDING Dubbing: Copying from deck 2 to 1 For best results, use mains power or fresh batteries. 1. Select TAPE source. 2. Press both STOP•EJECT 9/ keys and insert a recorded tape into deck 2 and a suitable tape for recording in deck 1. 3.
PRECAUTIONS AND SYSTEM MAINTENANCE • Place the set on a hard, flat surface so that the system does not tilt. • Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.