Installing A Dimm - Asus EX-B250M-V3 Manual

•
•
•
•
•
•

Installing a DIMM

1
To remove a DIMM
B
1-8
According to Intel CPU spec, DIMM voltage below 1.35V is recommended to protect
®
the CPU.
Due to the memory address limitation on 32-bit Windows
or more memory on the motherboard, the actual usable memory for the OS can be
about 3GB or less. For effective use of memory, we recommend that you do any of the
following:
- Use a maximum of 3GB system memory if you are using a 32-bit Windows
- I nstall a 64-bit Windows
motherboard.
- F or more details, refer to the Microsoft
com/kb/929605/en-us.
Memory modules with memory frequency higher than 2133 MHz and its corresponding
timing or the loaded X.M.P. Profile is not the JEDEC memory standard. The stability
and compatibility of these memory modules depend on the CPU's capabilities and
other installed devices.
The default memory operation frequency is dependent on its Serial Presence Detect
(SPD), which is the standard way of accessing information from a memory module.
Under the default state, some memory modules for overclocking may operate at a
lower frequency than the vendor-marked value.
For system stability, use a more efficient memory cooling system to support a full
memory load (2 DIMMs).
Refer to www.asus.com for the latest Memory QVL (Qualified Vendors List)
A
OS if you want to install 4GB or more on the
®
support site at http://support.microsoft.
®
2
Chapter 1: Product introduction
OS, when you install 4GB
®
A
A
OS.
®
B