Inspect The Exhaust Gas Temperature Sensor (Scr Inlet) Connector; Inspect The Exhaust Gas Temperature Sensor (Scr Inlet) - Hino 238 Workshop Manual

4–934
Was any failure found?
If damaged, replace the air flow sensor.
Perform "After-inspection work" of INFOR-
MATION section.
4

Inspect the exhaust gas temperature sensor (SCR inlet) connector

Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
5

Inspect the exhaust gas temperature sensor (SCR inlet)

Was any failure found?
Clean the exhaust gas temperature sensor
(SCR inlet) and install it properly.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE CONTROL SYSTEM (J08E)
YES
1. Check the connection of the exhaust gas temperature sensor
(SCR inlet) connector (Looseness and poor contact).
YES
1. Check the installation of the exhaust gas temperature sensor
(SCR inlet) .
2. Make sure there is no dirt or damage to the exhaust gas tempera-
ture sensor (SCR inlet).
YES
NO
Go to step 4.
NO
Go to step 5.
NO
Go to step 6.