Shindaiwa T2510 Operator's Manual page 26

Engine Operating
Speeds
Operate the machine at full throttle
while cutting. Best results are
obtained by releasing the throttle
when swinging back after completing
a cut.
 To prevent possible engine
damage, do not allow the
brushcutter to run at high speeds
without a load.
 Avoid operating the engine below
the recommended operational
speed range. Doing so can lead
to rapid clutch wear. In addition,
slow-speed operation may cause
grass and debris to wrap around
the cutting attachment.
Trimming/Mowing
Grass Using a Trimmer
Head
CAUTION!
Do not push the rotating trimmer
line into trees, wire fences or any
material that could entangle or
break line.
Your Shindaiwa T2510 and C2510
brushcutter can be equipped with the
recommended Shindaiwa trimmer
head.
CAUTION!
Operation at low speed may
cause premature clutch failure.
For best cutting performance and
extending trimmer line life, follow
these recommended procedures
when using a string-type cutting head.
See Figure 29.
26
Figure 29
 Cut from right to left, with the
trimmer head angled slightly
towards the cut.
 Use full throttle when cutting, then
release the throttle momentarily
before beginning the next cut.
 Cut only with the tip of the
trimmer line.