Creating Your First Sequences - Malekko VOLTAGE BLOCK Manual

CREATING YOUR FIRST SEQUENCES

Set to "CLOCK" or "SLAVE" (busboard
slave) or "CV" depending on your
setup. The Voltage Block always
requires an input or to slave in order to
play.
Patch the outputs to your other
module 1v/oct inputs for creating
melodies.
Adjust sliders for corresponding
channels - as you move the the slider,
the changes in voltage/pitch of each
step will be recorded.
NOTE: By default, there are 16 steps
per each GATE pattern/sequence.
If you're in CLOCK or SLAVE mode
and want to adjust the voltage of
particular step, hold the corresponding
STEP button while adjusting a slider.
Now you can change the SCALE of that
sequence by selecting the SCALE
button so that it's lit and then moving
the slider for that channel. You will see
the LED's light up for each correspond-
ing scale. See Pg.11 for all of the
available scales. IF THE SLIDER IS
SET ALL THE WAY DOWN, THE
VOLTAGES/PITCH WILL BE
UNQUANTIZED.
VOLTAGE BLOCK MANUAL V.1
PG. 6
MALEKKOHEAVYINDUSTRY.COM MALEKKOHEAVYINDUSTRY.COM
Follow these instructions
for GATE channels 2-8.
To clear an existing
sequence, simply
select SHIFT, select
the channel you wish
to clear and then
CLEAR (step #9).