Installation - Malekko VOLTAGE BLOCK Manual

VOLTAGE BLOCK MANUAL V.1

INSTALLATION

Remove module from packaging.
Power down your modular synthesizer and disconnect the power cable from the wall
outlet.
Attach the included power cable to the module's power connector and connect the
other end to the power distribution bus in your EuroRack synthesizer case. Match the
red stripe of the cable to the solid white line on your Voltage Block.
Position the module on the mounting rails in your EuroRack case and screw down
mounting screws. Power up! If your case does not turn on properly then you have
installed the module incorrectly. Simply power down and make sure to follow the
diagram when reconnecting the module.
RED STRIPE TO SOLID WHITE LINE
PG. 2
MALEKKOHEAVYINDUSTRY.COM