Volvo 740 1989 Owner's Maintenance Manual page 120

1989 Volvo 740
Fill coolant through the expansion tank. The heater controls should be fully open when draining and Filling.
Add coolant until the level is up to the MAX mark or slightly above.
Start engine and run until hot. Check the cooling system connections for tightness. Also re-check the coolant level.
Capacity: See "Specifications"
Coolant: Volvo coolant type C (blue green)
Caution!
The cooling system must always be kept filled to correct level. If it is not kept filled, there can be high local temperature in the engine which
could result in damage.
Top up with coolant
Top up with coolant by filling the expansion tank when level is at the "MIN" mark. Use a mixture of 50 percent anti-freeze/summer coolant
and 50 percent water all year round. Top up to the "MAX" mark.
WARNING!
If the engine is warm, and you are going to top up coolant, unscrew the cap slowly in order to allow any excess pressure to
escape.
NOTE: Do not top up with water only. Water by itself reduces the rust-protective and antifreeze qualities of the coolant and has a lower
boiling point. It can also cause damage to the cooling system if it should freeze.
pg. 111 Lubrication
No. Lubricating point
1 Hood lock and latch
2 Hood hinges
3 Door stop and hinges
4 Sunroof wind deflector
5 Door lock catch plate
6 Trunk lid lock
7 Window regulator Locking device (on inside of
door)
8 Front seat slide rail and latch
9 Door lock key hole
Classic Cars & Cycles
Lubricant
Paraffin wax
Oil
Oil
Oil
Paraffin wax or low temperature grease
Volvo Teflon lock oil
Oil, grease Silicone grease
Oil
Low temperature grease or Volvo Teflon lock oil.
www.ClassicCycles.org