Heatilator CRAVE4836-B Installation And Appliance Setup page 66

A. Vent Components Diagrams (continued)
14 IN.
356 mm
Note: Wire harnesses required to power the PVI-SLP-B connect to the appliance and are ordered separately from
PVI-SLP-B. Contact your dealer to order.
Note: A PVLP-HS heat shield is available and sold separately. Use if the PVLP-SLP is installed in a high traffic area.
Note: The PVI-SLP-B requires a PV-IPI-CK be installed on this appliance. The PV-IPI-CK is ordered separately from
the PVI-SLP-B. Contact your dealer to order.
PVLP-BEK
Brick Kit
Figure 12.6 PVLP-SLP Vent Components
Heatilator • CRAVE4836/ST-B, CRAVE6048/ST-B, CRAVE7260/ST-B, CRAVE8472/ST-B Installation Manual • 2301-973 Rev. H • 5/17
66
Top View
Front View
15-1/2 IN.
394 mm
8 IN.
203 mm
11-1/2 IN.
4-3/8 IN.
292 mm
112 mm
Power Vent Low Profile
PVLP-HS
Heat Shield
6-1/4 IN.
159 mm
1-1/2 IN.
38 mm
Side View
5-1/4 IN.
135 mm
10 IN.
254 mm
PVLP-SLP
DESCRIPTION
10 FT PV Wire Harness
20 FT PV Wire Harness
40 FT PV Wire Harness
60 FT PV Wire Harness
80 FT PV Wire Harness
100 FT PV Wire Harness
2-1/4 IN.
57 mm
4-3/4 IN.
121 mm
9-1/2 IN.
241 mm
2-1/4 IN.
57 mm
Required Wire Harness
PART NUMBER
PVI-WH10
PVI-WH20
PVI-WH40
PVI-WH60
PVI-WH80
PVI-WH100