Configuring Client Pc; Tcp/Ip Configuration; Windows 98/Me - Philips SNA6640 User Manual

Configuring Client PC

After completing hardware setup by connecting all your network devices, you need
to configure your computer to connect to the ADSL Wireless Modem Router.
See:

TCP/IP Configuration

To access the Internet through the ADSL Wireless Modem Router, you must
configure the network settings of the computers on your LAN to use the same IP
subnet as the ADSL Wireless Modem Router. The default IP settings for the ADSL
Wireless Modem Router are:
IP Address
Subnet Mask
DHCP function
DHCP IP Pool Range
Note: These settings can be changed to fit your network requirements, but you must first
configure at least one computer to access the ADSL Wireless Modem Router's web
configuration interface in order to make the required changes. (See 'Configuring the
ADSL Wireless Modem Router' on page 20 for instruction on configuring the ADSL
Wireless Modem Router.)

Windows 98/Me

You may find that the instructions in this section do not exactly match your version
of Windows. This is because these steps and screen shots were created from
Windows 98. Windows Millennium Edition is similar, but not identical, to Windows
98.
1 On the Windows desktop, click Start/Settings/Control Panel.
2 In Control Panel, double-click the Network icon.
'Windows 98/Me' on page 9
'Windows NT 4.0' on page 12
'Windows 2000' on page 14
'Windows XP' on page 14
'Wireless adapters' on page 17
192.168.1.1
255.255.255.0
Enable
192.168.1.2 to 192.168.1.254
EN
9