Advertisement
Available languages
Available languages
RISK OF INJURIES
CAUTION: Always wear protective
gloves when working with and around
cutting tools.
The petrol cutting blade is supplied with attached
cutting blade (11) and associated guard (12).
To use the petrol cutting blade as grass trimmer,
proper guard (12) and line spool (13) must be
attached.
The cutting protection can be installed like pictures B5-1
and B5-2.
- Use a screwdriver, or the supplied Allen key (14)
to fix the shaft of the petrol brush cutter at the intended
location (B6) by a locknut.
- Use the supplied hexagon wrench (15) to loosen
the hexagonal screw for attachment of the cutting blade
(B7) by turning it in clockwise direction.
- Remove the hexagonal screw, the lock washer,
and the retaining disk for the cutting blade (B8).
Keep these parts at a safe location.
- Attach the locking part (B9).
- Use a screwdriver, or the supplied Allen key to fix the
shaft of the petrol cutting blade
at the intended location by a locknut (B10).
- Now screw the line cassette (13) onto the shaft in a
counter-clockwise direction (B10).
CAUTION: Left-handed Thread
Assembly of Cutting Blade
To avoid the risk of an unwanted engine start,
pull out the spark plug socket.
RISK OF INJURIES
CAUTION: Always wear protective
gloves when working with and
around cutting tools.
The cutting blade must be sharpened periodically
according to instructions. Improperly sharpened or blunt
cutting edges may cause the tool to overload.
RISK OF RUPTURES and CRACKS
Fragments hurled away from the cutting tool can
cause extremely severe injuries.
To use the petrol cutting blade as an
engine powered trimmer, the proper guard and
cutting blade must be attached.
- Use a screwdriver, or the supplied Allen key to fix the
shaft of the petrol cutting blade
at the intended location by a locknut. Now remove the
line cassette (13) from the shaft by turning it in clockwise
direction (B11).
- Place the cutting blade (12) on the locking part.
- Place the retaining disk (observe side) and the lock
washer on the cutting blade (11) (B13).
- Use a screwdriver, or the supplied Allen key to fix the
shaft of the petrol cutting blade
at the intended location by a locknut. Screw the
hexagonal screw on the shaft in anti-clockwise
direction, and use the supplied hexagonal
wrench (15) to tighten this screw (B14).
CAUTION: Left-handed Thread
Assembly of Carrying Strap
The petrol cutting blade must be used with a
carrying strap (17).
First, balance the petrol brush cutter
when the tool is swithced off.
- Wear the shoulder strap (17).
- Adjust the strap length so that the snap hook is
roughly one hand below the right hip (B15).
G
B
15
Advertisement
