Table of Contents
Advertisement
2. CYCLONIC DUST BOX
(See D)
A) ATTACH THE CYCLONIC
DUST BOX
Your sander is equipped with a
cyclonic dust box. To attach, slide
the box onto the outlet piece and
take care that the latching lever
engages.
CAUTION!
To prevent the possibility of sanding
dust or foreign body being thrown
into your face or eyes, never attempt
to use your sander without the dust
box properly installed.
B) EMPTY THE CYCLONIC
DUST BOX (See D1 D2)
For more efficient operation,
empty the cyclonic dust box every
5-10mins. This will permit the air to
flow through the box better.
To empty the box, press the latching
lever in and pull off the box. Then
press the button at the rear of the
box to open it, and shake out dust.
3. OPERATING THE ON/
OFF SWITCH (See E)
To start your sander, depress the
protective cover over the switch
indicated by the mark "I".
To stop your sander, depress the
protective cover indicated by the
mark "0".
Positec Australia Pty Limited
Unit 15, 23 Narabang Way, Belrose 2085 NSW Australia
www.jcb-tools.com
Customer Helpline 1300 889 028
D1
D2
E
Advertisement
Table of Contents
