Advanced Features Of The Digital Controller - Daikin EWAP110MBYNN Operation Manual

Advanced features of the digital controller

This chapter gives an overview and a brief functional description of
the screens provided by the different menus. In the following chapter,
you will find how you can set up and configure the unit using the
various menu functions.
All menus are directly accessible using the corresponding key on the
digital controller or through the main menu (refer to
menu" on page 6). The down arrow X on the display indicates that
you can go to the next screen of the current menu using the h key.
The up arrow W on the display indicates that you can go to the
previous screen of the current menu using the g key. If C is
displayed, this indicates that you can either return to the previous
screen or can go to the next screen.
Readout menu
Setpoints menu
Depending upon the settings in the user settings menu, the
"setpoints" menu can either be entered directly or by means of the
user password.
Usersettings menu
The "usersettings" menu, protected by the user password, allows a
full customization of the units.
Operation manual
9
"How to enter a
To consult actual operational
information about the control mode, the
inlet and outlet water temperature (see
first screen).
Note that for a DICN system, the
and values are
the values of the individual units, not of
the system. Temperatures of the system
can be consulted in the first screen of
the network menu.
To consult information about the unit
status.
To consult information about
pressures.
To consult actual operational
information about the
temperature, the total running hours of
the compressor and the number of
compressor starts.
To define the temperature setpoints.
To define the manual settings and to
activate or deactivate manual control
mode.
To define the thermostat settings.
To define the capacity limitations. (first
screen)
To define the capacity limitations.
(second screen)
To define the pump control settings.
the
ambient
Timers menu
To define the schedule timer.
According to the settings of
and
following screens will be available or
not.
To define the dual evaporator pump.
To define the floating setpoint.
To define the display settings (first
screen).
To define the display settings (second
screen).
To define the free cooling.
To define the number of slaves for a
"master" unit. This menu can only be
accessed at the "master" unit!
The controller displays the name of the
unit: , ...
name is automatically assigned
depending on the set hardware
address. Refer to "Setting
adresses" in "Connection and setup of
a DICN system" in the installation
manual.
To define wheter or not a password is
needed to enter the setpoints menu.
To enter the service menu (only a
qualified installer is allowed to access
this menu).
To check the actual value of the general
software timer.
To check the actual value of the
compressor timer. (first screen)
To check the actual value of the
compressor timer. (second screen)
To check the actual value of the
compressor startup timer and the stop
timer.
EWAP110~340MBYNN
Packaged air-cooled water chillers
4PW22677-1
. This
the