Sony CLM-FHD5 Operating Instructions Manual page 14

 Rotate the dial of the shoe
adaptor fully in the  (LOCK)
direction to fix it firmly to
the camera.
When attaching to a camera
read the instruction manual of
the camera too.
Notes
• If using a camera equipped with a
pop-up built-in flash, be careful of
the following:
– Always close the built-in flash of
the camera. If your camera has a
built-in auto flash function, turn
that function off.
– Before using the flash, remove
this unit from the camera.
• Make sure this unit is firmly
fixed to the camera before use
to prevent this unit from falling
during shooting.
14
-GB
4
Connect this unit to the
camera with the correct type
of HDMI cable supplied.
• If the cable is not long enough,
use a Sony HDMI cable (not
supplied).
Notes
• When this unit is connected to
the camera by the HDMI cable,
the following may happen
depending on the camera.
– No image appears on the
camera's LCD screen.
– The camera switches to
playback mode. (Make sure
the camera is in shooting
mode before taking
pictures.)
• After a certain time in either of
the following conditions, the
backlight of this unit turns off.
– No HDMI signal is output
from the camera
– The HDMI cable is
disconnected