Match Lighting Instructions; Damper Adjustments - Smoke hollow SH3616DW Owner's Manual

Operating Instructions
To add water to the smoker, simply open the side water fill doors on both sides of the smoker and slowly
pour water from a cup or pitcher into the opening. Fill the Water Pans up to about an inch from the top of
the pans. For easier cleaning, line the water pans with aluminum foil before each use.
1. Check all connections for leaks (see page 20)
2. Open smoker doors
3. Check for any blockage to the venturi tube or burner. Remove any foreign objects or matter.
4. Be sure the burner control knobs are in the "OFF" position.
5. Open the LP cylinder valve 1 1/2 turn by turning knob counter clockwise.
6. To light unit, push in and turn the burner control knob counter clockwise to the "HIGH" setting.
7. Then press and hold the black button igniter. There will be clicking and sparking until the
burner is lit. If the burner does not light within 3 to 5 seconds, turn the burner control knob
"OFF" and wait five minutes before repeating the steps again. If burner still fails to light, try
match lighting the smoker using the instructions noted below.
8. Once the burner is lit, then close the door to allow heat to accumulate. The damper can then be
adjusted to the desired setting to allow proper air flow and combustion. Damper adjustment
tips are listed on the next page.

MATCH LIGHTING INSTRUCTIONS

1. To match light the burner, repeat steps 1 through 5 of the lighting procedure above and
continue with the following steps.
2. Remove the wood chip trays from the smoker. Strike a paper match and place it into the burn
chamber, next to the burner.
3. Quickly turn the control knob to the light high setting. If the burner does not light within 4 or
5 seconds, turn the control knob off, wait 5 minutes, and repeat the process.
4. If the burner flame is accidentally extinguished, turn the control knob off, wait 5 minutes, and
repeat the lighting procedure.
Temperature maintenance is best contolled by different damper adjustments. The key to effective
smoking is to watch your heat indicator on the door and adjust the damper accordingly. For better
performance, rotate the smoker to where the front of the cabinet is facing the wind. This allows the
adjustment of the damper to be more effective and accurate. Opening the damper helps to exhaust
both the heat and smoke. The damper should never be fully closed.
ADDING WATER TO SMOKER
LP GAS LIGHTING PROCEDURE

DAMPER ADJUSTMENTS

22